Sink & Faucet Installation in Columbus, OH
Kitchen, bathroom vanity, and utility sink installations with leak-free plumbing hookups.
Sink & Faucet Installation: What This Service Covers
Sink and faucet installation is the full swap-out of a kitchen sink, a bathroom vanity, a utility tub, or a bar sink: removing the old fixture, setting the new one level and sealed, reconnecting the supply lines and drain, and leak-testing the whole assembly. Our Columbus installers handle the awkward parts that turn a DIY job into a weekend-killer: corroded shutoff valves that need replacing, trap adapters that don't fit the new drain, granite or quartz countertops that need a careful mount, and supply lines that are a hair too short. We also install new faucets on existing sinks, garbage disposals, and pull-out sprayers. Every install is leak-checked under pressure and secured to code before we clean up.
Our Sink & Faucet Installation Process
Measure & Prep
We confirm the new sink or faucet fits the existing cutout, check the supply lines and shutoffs, and protect the countertop before we start.
Remove Old
We disconnect the supply lines and drain, break the old sink or faucet seal, and lift out the fixture without cracking the counter.
Set & Seal
We set the new sink level, seal the rim, mount the faucet, and connect fresh supply lines and a properly sized trap adapter.
Test & Clean
We run both hot and cold under full pressure, confirm the drain holds, and clean up the work area before we leave.
Benefits of Our Sink & Faucet Installation
Leak-Free From Day One
A level, sealed install with fresh supply lines means no slow leaks under the cabinet that quietly rot the floor and cabinetry over the next year.
A Clean, Finished Look
A properly mounted sink and faucet sits flush and sealed, with no caulk gaps or wobble that cheapens the look of a new kitchen or bathroom.
Works the Way It Should
Supply lines sized right and a trap that drains freely mean full flow and no gurgling. The fixture just works, every single day, the way it was meant to.
Related Plumbing Services in Columbus
Sink & Faucet Installation Across the Columbus Area
Sink & Faucet Installation FAQs in Columbus
How long does a sink or faucet installation take?
Most Columbus sink and faucet installs finish in two to four hours in a single visit, depending on the condition of the existing plumbing.
How much does sink installation cost?
Typical installs run $150 to $450 depending on the fixture and any supply-line or shutoff work. Some prices may vary based on scope.
Will you replace my shutoff valves too?
If the old angle stops are corroded or won't close, we replace them as part of the job and quote it upfront before we start.
Do you install the faucet I already bought?
Yes. We install homeowner-supplied sinks, faucets, and disposals, and we flag anything that won't fit before we start the work.
Do you stand behind your work?
100%. Our company motto is 'Integrity & Service After the Sale.' We honor warranties on all workmanship and installations.
1285 Studer Ave, Columbus, OH 43206